L019 | Dry block heater with aluminium block options for 53 or 103 microtubes of various sizes
- Block options for 53 or 103 microtubes of various sizes
- Can be used with 0.2, 0.5 and 1.5 mL microtubes
- LCD temperature display and timing range up to 96 hours
- Cycle completion signal
The TDB-120 dry block heat bath from Biosan provides capacity for either 53 or 103 microtubes of various sizes and is ideal for extended operation up to 96 hours. It can be used to heat samples in 0.2 mL, 0.5 mL or 1.5 mL microtubes depending upon which aluminium block configuration is installed.
The heating range for the Bio TDB-120 is from 5°C above ambient to 120°C and the actual and set temperatures are shown on the LCD display. The unit features a timer and the lid of the dry block bath can be closed to provide operator protection from hot blocks and to increase temperature stability. The unit is controlled through a touch pad.
Heating times to reach specific temperatures are as follows:
|From +25°C to +37°C||4 minutes|
|From +25°C to +120°C||25 minutes|
The following aluminium block options are available for the TBD-120:
|A-53||Block for 21 x 0.5 mL and 32 x 1.5 mL microtubes|
|A-103||Block for 21 x 0.5 mL and 32 x 1.5 mL and 50 x 0.2 mL microtubes (shown below)|
|Temperature setting range||25°C to 120°C|
|Temperature setting resolution||0.1°C|
|Temperature control range||5°C above ambient to +120°C|
|Temperature stability at 37°C||±0.1°C|
|Temperature uniformity at 37°C||±0.1°C|
|Timer range||1 minute to 96 hours in increments of 1 minute or continuous|
|Block tube capacity||53 or 103 tubes of various sizes depending on installed block|
(W x D x H)
|230 mm x 210 mm x 110 mm|
|Power||230 V: 50/60 Hz|
Advance Scientific Products Pty Ltd is based in Queensland and is focused on delivering high-quality products and service to our customers in the life, chemical and analytical sciences across Australia.
The company was established in 2013 by experienced instrumentation specialists to provide full distribution and customer support capability to manufacturers seeking to expand their activities in Australia without having to create their own sales and marketing infrastructure.
PO Box 746
Moffat Beach, QLD, 4551, Australia